Cut out your tree pattern using standard computer paper (you may need to repeat this step later)
Pin your tree pattern to the edge of the felt
Cut out the tree pattern and repeat 6x
Using hot glue gun, glue the edges of 2 felt trees together
Continue to glue 2 edges together until all 6 trees are glued together
Cut your wooden dowel to your desired length using wire cutters or scissors (note: if you are using the small wooden knobs as the base you cannot cut your dowels too tall or they will not stand up, the weight of the felt will knock them over)
Place one side of the wooden dowel into the center of the glued together felt trees
In the small opening where the wooden dowel meets the top of the trees, place a small amount of hot glue and hold until dry
Repeat at the point that the wooden dowel meets the bottom of the trees it
Place a small amount of hot glue in the hole of the wooden knob
Place the bottom end of the wooden dowel into the hole and hold until dry